How to use your LAN port to remotely wake up your Supermicro NVR server after showdown ?Easy for NVR remote maintenance.
There are 3x steps to wake up your NVR from a remote PC.
Configure your Supermicro NVR server BIOS
Supermicro NVR BIOS Config
Hit the <Delete> key while the system is booting-up
Go to Advanced → PCIe/PCI/PnP Configuration
Make sure Item: IPv4 PXE Support [Enabled]
Hit the <F4> key for save and exit BIOS setting mode
Configure your Supermicro NVR Windows OS
Supermicro NVR Windows OS Config
Bring up your NVR Server after BIOS configuration is done
Right-click on the Start button and select Computer Management
Go to Device Manager and select Intel® I210 Gigabit Network Connection Properties
Go to Advanced, select Wake on Magic Packet, Enabled
Go to Advanced, select Enable PME, Enabled, hit OK to save
Go to Power Management, select all
Exist Computer Management and restart your NVR
Send your Wake-up signal by a 3rd party software
Send out Wakeup signal from Remote
Download WakeMeOnLan software from https://www.nirsoft.net/utils/wakemeonlan-x64.zip
Install your WakeMeOnLan sw on whatever PC you want to wake up your Supermicro from
Add your Supermicro NVR IP address to WakeMeOnLan by Add New Computer
Send Wakeup signal to your Supermicro NVR by Wake up Selected Computers
GVD Mia